One of my daughters had a birthday recently. We took her and her family as well as our other daughter and her family out to lunch to celebrate. The day before her birthday I thought about tatting her something (I always leave it to the last minute.) Earrings can be quick and easy – relatively speaking – so I decided to make her a pair.
The dragonfly wing beads I bought last year from JoAnn’s, the same time I bought the beads for these earrings. I used Lizbeth metallic thread #311 for the finished earrings, but, I didn’t start with that thread. I wasn’t quite sure how I was going to make them so I practiced with cotton thread first.
My first try was with cotton thread and single shuttle split rings. I was not happy with them at all. They might be good after a bit more refresher practice, but there was a time limit for getting them made. I like the look of the split rings in the middle one, but they looked a bit too big. So I made the split rings a bit smaller, which resulted in a happy tatter and a pretty set of earrings.
I used a few other beads bought at the same time for my Christmas gift ornaments this last year. They were made almost the same way as the earrings but with different stitch counts.
The biggest issue I had with these ornaments was I couldn’t put them in my Christmas cards to send them! Which in a way was good, as I didn’t have enough beads to make as many ornaments as I usually do. But those that received them were thrilled with them.
I don’t tat with beads often, usually because I make messes with them. I tat a lot in the car, so beads end up on the floor, between the seats, or lost. Okay, I’m also impatient with how much slower I tat with beads than tatting without. But once in a while beads are fun to work with, and usually turn out pretty good.
“The greatest gifts you can give your children are the roots of responsibility and the wings of independence.” Denis Waitley
I wouldn’t even attempt to tat with beads in the car! Love your dragonfly earrings, and the ornaments.